(82MM 3MM PLANER) - ZKK-8200HD

A planer is used to smooth and level the flat surfaces of a board to a consistent thickness, while a jointer is used to create a square surface on the edge of a board. Jointers are also used to face joint one side which allows the planer to create parallel surfaces with uniform thickness. A handy tool for trimming interior doors, panels and skirting boards. Hand planer for up to 3 mm planing depth and 82 mm planing width. Depth adjustment is easy with the thumbwheel. Removable chute port on left or right side. Used in the initial preparation of wood, producing flat faces and square edges. Problems can occur when fingers get dragged between the fence and guard and contact the cutters. There are four cutters, held in place horizontally with eight allen screws. Cutter height is adjusted with a gauge. A planer is a woodworking tool used to smooth and shape wood surfaces and workpieces. It consists of a cutting head with multiple blades that remove thin layers of wood with each pass. Planers are commonly used in woodworking projects to create flat, even surfaces on rough lumber. The main benefit of electric hand planers is efficiency. Electric hand planers can handle larger tasks due to their powerful motors and ability to move more quickly than traditional hand planers. This efficiency means you can get the job done faster wit h less effort. If the wood is too thick, you can simply reduce the material thickness with the electric planer. The planer is also ideally suited for smoothing rough wood surfaces. Likewise, you can use skewed or poorly cut wood for furniture construction by planing it flat beforehand. A planer thicknesser really makes joinery easier and releases you from the frustration and expense of relying on pre-prepared timber, helping to reduce cost and improve quality. of relying on pre-prepared timber, helping to reduce cost and improve quality. The minimum length is 12 inches and the minimum thickness is¼ inch. A board that is too short can kickback towards you. 12. Do NOT look directly into the planer while it is running.